ComNav Technology Sino GNSS N5 - Button and LED Functions

SinoGNSS
○
R
N5 User Guide
10
3.2 Button functions
There are two buttons on the front panel, power button and record button.
 Power button:
Press the power button for about 1 second to turn on the receiver;
To turn off the receiver, long press the button for 3-4 seconds until all LEDs off.
 Record button:
Switch to static mode：Long press the record button for about 2 seconds, release
immediately when hearing beep from receiver;
Switch to RTK mode: press the button until Raw Data recording LED off.
Tip: The record button only works when receiving satellite signals, otherwise it will show timeout.
3.3 LED behavior
The LEDs on the front panel indicate receiver working status. Generally, a lit or
slowly flashing indicates normal operation, and an unlit LED indicates that no
operation is occurring. The following figure and table define each possible LED
state:
LEDs
States
Description
Differential Data
Flashes once per second
Receiving/transmitting differential
data
Satellite Tracking
Fast flashing
No satellite received
Flashes N times every 5 seconds
Received N satellite signals
Differential Data
Satellite Tracking
OLED display
Raw Data Recording
Power