Compac CNG

Connecting Mains Power
Electrical Installation
Compac Industries Ltd.
Page 14
www.compacngv.com
Connecting Mains Power
In sites where the electrical supply is unstable, it is
recommended that a power conditioner or UPS is installed.
To connect the loading post:
1. Wire the power to the C4000 Termination Board, as shown in the
diagram below. (Comms option is not available)
2. Connect the earth lead of the supply cable to the earth stud in the
flameproof junction box.
All cables must be terminated with approved flameproof
glands. The thread is 20 mm.
Typical wiring