Compac CNG

Set-up
Parameter switch
Compac Industries Ltd.
Page 17
www.compacngv.com
Set-up
The parameter and K-Factor switches on the C4000 board are used to set
up and calibrate the post.
Parameter switch
The loading post is pre-programmed and the parameter switch would not
normally be used. Information on this switch can be found on the C4000
manual.
K-Factor Switch
The K-Factor switch is located on the C4000 indicator board. You can use
this switch to set the density factor (changing the units the display reads in)
and the meter calibration.
Figure 1: Parameter and K-Factor
switches.