The C configuration code (C) changes the operation of the loading post. It
is the last setting accessed through the K-Factor switch. The configuration
code has been factory set and should not be changed. If the memory gets
wiped and you need to re-enter it, the configuration is written on the yellow
label on the C4000 processor board cover.
1. Make sure that the post in not in use.
2. Press and release the K-Factor switch until C is displayed.
3. Enter the new C configuration see diagram below.
Each press of the K-Factor switch passes you over a digit
in a setting, making the digit blink. Holding the switch down for more than
a second changes whichever digit is currently displayed. If you want to
pass over a setting without changing any digits, keep pressing and
releasing the switch.
4. Let the menu time out so that the value and quantity amounts are
displayed.
To Next Page
Loading...
Need help?
General
