Transportation, installation and storage
A190-930TX_EN_03_ 2009-02-06 23
Note:
The vessels are filled with layers of various desiccants. They should
therefore be transported in an upright position in order to prevent the
mixing of these desiccants, as this could impair the operation of the
dryer.
Risk of tilting!
The dryer should only be transported in an upright position. However, this
means that the centre of gravity of the unit is located in the middle of the
dryer, so that there is a serious risk that the unit might tilt over.
Therefore, adhere to the transport instructions outlined as follows.
Transport by crane
► Transport the dryer in an upright position to
its location of installation.
► For this purpose, attach a girder with suitable
fixtures to ensure that the dryer is lifted at the
centre and that the upper pipe bridge is not
crushed between the vessels (see figure).
Transport by crane
Transport by forklift
► When using a forklift, ensure that the dryer is always in an upright position.
► Secure the dryer to ensure that it cannot tilt or fall from the forklift.
To Next Page
Loading...