Compak K3 - Grinder Regulation and Adjustment; Initial Grinder Setup

12
K09652H00 | PROC-CAL/002/03 USER MANUAL | V. 29/06/2023
. ADJUSTMENT
. GRIND ADJUSTMENT SYSTEM
8.2.1 Rotate the grind regulator ( ) until
reaching the grind level desired.
Rotating the grind regulator clockwise will
result in a courser grind; turning the regulator
counterclockwise will result in a finer grinder
(Fig. 1).
Fig. 1
Only for a K6 model: Once you reach
the desired grinding point, you can fix the
grinding regulation using the regulation
brake ( ) (Fig. 2).
Fig. 2
NOTE: If the coee
throughput is very low, this
is because the coee is
being ground very fine. If
the throughput is very high,
this is because the coee is
being ground very coarse. A
perfect Espresso is produced
when the grinding gives an
infusion of 25 ml of coee in
25 seconds using about 7 g of
ground coee.
NOTE: It is recommended
that this operation be
performed, when changing
to a finer grinding, with the
motor running, to prevent
coee from building up
between the burrs and
blocking the grinder.