Compak K3 - Grinder Installation Prerequisites

11
K09652H00 | PROC-CAL/002/03 USER MANUAL | V. 29/06/20023
. ADJUSTMENT
8.1.3 Remove the hopper lid ( ), fill the
hopper with coee ( ), and replace the lid
on the hopper ( ) (Fig. 3).
Fig. 3
8.1.4 Plug in the grinder, and press the main
power switch ( ) to ON position, and open
the bean trap ( ) to allow coee to pass into
the grind chamber (Fig. 4).
Fig. 4
. GRINDER SET UP
8.1.1 Place the hopper ( ) on the grind
regulator ( ) and make sure the bean trap
( ) is in the closed position (Fig. 1).
Fig. 1
8.1.2 Lock the hopper ( ) in place using a
phillips head screw driver to gently tighten
the hopper security screw making it match
to the hole at the bean hopper collar ( ) (Fig.
2).
Fig. 2