Compak K3 - Identification; Technical Characteristics

7
K09652H00 | PROC-CAL/002/03 USER MANUAL | V. 29/06/20023
The technical characteristics
plate is indelibly marked with
the following information:
. IDENTIFICATION
. SCOPE
The coee grinders are intended for
commercial applications where ground
coee must be used, or in small shops
selling coee, but not for continuous mass
production of food.
This grinder should only be
used to grind coee beans.
Any other use is considered
improper and dangerous.
NOTE: The manufacturer reserves
the right to change the machine
components, according to the
requirements of each market, and
also for technological advances.
NOTE: The manufacturer is not
liable for damage to persons, goods
or the machine itself, if the safety
regulations given in this manual are
not followed, or the machine is used
incorrectly.
. TECH. CHARACTERISTICS
.. TECHNICAL DATA
Model
100 V
50 Hz
100 V
60 Hz
110 V
60 Hz
220 V
60 Hz
230 V
50 Hz
240 V
50 Hz
K3
Electrical Power
200 200 175 210 220 255
W
Rotational Velocity
1320 1620 1640 1700 1380 1400 rpm
K6
Electrical Power
230 230 245 375 375 375 W
Rotational Velocity
1320 1620 1100 1700 1380 1400 rpm
* Production based on a medium roast coee and Espresso grinding point.
Ø Flat Burrs Production 50 Hz* Production 60 Hz*
K3 58 2,3 3,7 8,2 4,3 9,5
K6 64 2,5 6 13 7 15
mm in Kg/h lb/h Kg/h lb/h
Dose Capacity Lever Position Net weight Height x Width x Depth
K3 300 0,66 Right or Left 6.8 15,7 660x230x384 26x9,1x15,1
K6 300 0,66 Right or Left 13,8 30,4 660x230x384 26x9,1x15,1
g lb Side Kg lb mm in