14
K09652H00 | PROC-CAL/002/03 USER MANUAL | V. 29/06/2023
. CLEANING
. TAMPER
Position the portafilter below the tamper ( ) and
push up to tamp the ground coee (Fig. 2).
Fig. 2
. OPERATION
. GENERAL CLEANING
To ensure that the grinder functions properly,
and produces the highest quality grind
possible, the parts that come into contact
with coee should cleaned periodically.
General Cleaning guidelines as follows:
Always turn the main power switch to the o
position ( ).
Unplug the machine from the power source.
Do not submerge the grinder in water or use
power washing devises.
The appliance is not to be cleaned with a
water jet or a steam cleaner.
. BEAN HOPPER CLEANING
In order to properly clean the bean hopper
( ), first empty out all remaining beans and
fragments.
To remove the hopper, first close the bean
trap ( ), and then loosen the hopper lock
screw ( ) and lift the hopper straight up.
Clean the hopper ( ) with a moist soft cloth
or with a small amount of water and neutral
soap to eliminate any oily residue from the
beans.
Replace the bean hopper ( ) following the
same steps as the removal process, but in
reverse.
To Next Page
Loading...
