Compaq 486 - Page 31

610 - 02 Exceeded maximum
hard error limit
610 - 03 Previously exceeded
maximum soft error limit
-----------------------------------------------------------------------------
Error Recommended
Code Description Action
-----------------------------------------------------------------------------
610 - 04 Previously exceeded The following steps apply
maximum hard error limit to error codes 600 - xx
through 610 - xx:
610 - 05 Failed to reset controller 1. Replace the diskette
and retest.
610 - 06 Fatal error while reading 2. Replace the diskette
drive and retest.
610 - 07 Fatal error while writing 3. Replace the I/O board
and retest.
610 - 08 Failed compare of 4. Replace the power
write/read buffers distribution board and
retest.
610 - 09 Failed to format a track
610 - 10 Failed sector wrap test
610 - 20 Failed to get drive type
610 - 21 Failed to get change
line status
610 - 22 Failed to clear change
line status
610 - 23 Failed to set drive type
in ID media
610 - 24 Failed to read diskette
media
610 - 25 Failed to verify diskette
media
610 - 26 Failed to read media in
speed test
610 - 27 Failed speed limits
610 - 28 Failed write protect test
-----------------------------------------------------------------------------
Error Recommended
Code Description Action
-----------------------------------------------------------------------------
697 - 00 Diskette type error The following steps apply
to error codes 697 - xx and
698 - xx:
698 - 00 Diskette drive speed 1. Replace the diskette
not within limits and retest.
2. Replace the diskette
drive and retest.