Compaq 486 - Page 35

1202 - 21 Modem timed out waiting documentation for
for SYNC (analog loopback Configuration utility
answer mode) procedures.
2. Check the modem line.
1202 - 22 Modem timed out waiting 3. Replace the modem
for modem response (analog and retest.
loopback answer mode)
1202 - 23 Modem exceeded data
block retry limit (analog
loopback answer mode)
1203 - xx Modem External
Termination Test
1203 - 01 Modem external
TIP/RING failure
1203 - 02 Modem external DATA
TIP/RING failure
1203 - 03 Modem line termination
failure
1204 - xx Modem Auto Originate
Test
1205 - xx Modem Auto Answer
Test
-----------------------------------------------------------------------------
Error Recommended
Code Description Action
-----------------------------------------------------------------------------
1206 - xx Dial Multifrequency Tone The following steps apply
Test to error codes 1201 - xx
through 1210 - xx:
1210 - xx Modem Direct Connect 1. Refer to modem
Test documentation for
Configuration utility
1210 - 01 Modem timed out waiting procedures.
for SYNC 2. Check the modem line.
3. Replace the modem
1210 - 02 Modem timed out waiting and retest.
for response
1210 - 03 Modem exceeded data
block retry limit
1210 - 04 RCV exceeded carrier
lost limit
1210 - 05 XMIT exceeded carrier
lost limit
1210 - 06 Time out waiting for dial
tone
1210 - 07 Dial number string too
long