Compaq 486 User Manual

1906 - 08 Unable to servo write
-----------------------------------------------------------------------------
Error Recommended
Code Description Action
-----------------------------------------------------------------------------
1906 - 09 Unable to format The following steps apply
to error codes 1901 - xx
1906 - 10 Format mode error through 1906 - xx:
1. Replace the tape
1906 - 11 Drive recalibration error cartridge and retest.
2. Replace the tape
1906 - 12 Tape not servo written drive and retest.
3. Replace the I/O board
1906 - 13 Tape not formatted and retest.
1906 - 14 Drive timeout error
1906 - 15 Sensor error flag
1906 - 16 Block locate (block ID)
error
1906 - 17 Soft error limit exceeded
1906 - 18 Hard error limit exceeded
1906 - 19 Write (probably ID) error
1906 - 20 NEC fatal error
1906 - 21 Received servo pulses
second time but not first
1906 - 22 Never got to EOT after
servo check
-----------------------------------------------------------------------------
Error Recommended
Code Description Action
-----------------------------------------------------------------------------
1906 - 23 Change line not set The following steps apply
to error codes 1901 - xx
1906 - 24 Write protect error through 1906 - xx:
1. Replace the tape
1906 - 25 Unable to erase cartridge cartridge and retest.
2. Replace the tape
1906 - 26 Cannot identify drive drive and retest.
3. Replace the I/O board
1906 - 27 Drive not compatible with and retest.
controller
1906 - 28 Format gap error
1906 - 30 Exception bit not set
1906 - 31 Unexpected drive status
1906 - 32 Device fault
1906 - 33 Illegal command

Compaq 486 Specifications

General

Brand	Compaq
Model	486
Category	Desktop
Language	English