EasyManuals Logo

Compaq CT101 User Manual

Compaq CT101
29 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #2 background imageLoading...
Page #2 background image
FCC Information
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used
in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to radio
or television reception, which can be determined
by turning the equipment off and on, the user is
Safety precautions
encouraged to try to correct the interference by one
or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment
and receiver.
Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV
technician for help.
- 1 -
Warning: Changes or modifications not
expressly approved by the party responsible for
compliance (MLB International Inc., PO Box 1214,
Lockport, NY, 14095, Tel: 716-240-0902) could void
the user’s authority to operate the equipment.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Compaq CT101 and is the answer not in the manual?

Compaq CT101 Specifications

Power IconPower
power inputDC IN 5V