Reference Guide
3-3
Writer: Dianne Fielden Saved By: Troy Witte Saved Date: 07/24/97 4:42 PM
Pages: 6 Words: 1022 Template: c:\template\commercial\comm.dot
File Name Ch3.doc Part Number 308336-001
Identifying the
Network Connectors
The following Ethernet connectors are built into the computer
on the rear panel:
■
RJ-45 (8-pin) connector
■
AUI (15-pin) connector
✎
An AUI-BNC transceiver is optional.
The network can only be active on one connector or the other.
By default, your computer is configured for 10/100 operation
with the RJ-45 connector. To enable the AUI connector,
complete the following steps:
1. Double-click the Network icon, located in the Control
Panel.
2. Double-click the Compaq Netelligent 10/100 TX
Embedded UTP Controller.
3. Select the Advanced Properties tab.
4. Select Media Connector.
5. Change the value to AUI.
6. Exit the Network control application.
You will be prompted to restart your computer in order for
the changes to take affect.
To Next Page
Loading...
