Hardware Reference Guide B-5
Compaq Confidential - Need to Know Required
Writer: Kristen Cover Part Number: 123456-001 File Name: f-appb.doc
Last Saved On: 07/25/00 8:05 AM Last Saved By: Kristen Cover
Using SCSISelect with SCSI Devices
The Wide Ultra160 SCSI host adapter includes the SCSISelect utility
to configure the host adapter and to run SCSI disk utilities. To run the
SCSISelect utility:
■ In Post Messages Enabled mode: Press Ctrl+A when the Press
<Ctrl><A> for SCSISelect Utility message appears during POST.
■ In Post Messages Disabled mode: When the Compaq logo screen
appears, press any key to exit the logo screen. Immediately after
exiting the logo screen, press Ctrl+A to access the SCSISelect
utility.
A menu appears with the following options:
■ Configure/View Host Adapter Settings
❏ SCSI Bus Interface Definitions
–
Host Adapter SCSI ID
–
SCSI Parity Checking
–
Host Adapter SCSI Termination
❏ Additional Options
–
Boot Device Options
–
SCSI Device Configuration
–
Advanced Configuration Options
■ SCSI Disk Utilities
Lists all SCSI devices and SCSI ID numbers
✎
For information about configuring POST message display
status, refer to the Computer Setup guide.
To Next Page
Loading...
Need help?
General