not connected codes 401 - xx through 403 - xx:
402 - xx Failed Port Test 1. Connect the printer.
2. Check power to the printer.
403 - xx Printer pattern test 3. Install the loopback connector and
failed retest.
4. Check port and IRQ configuration.
5. Replace the system board and retest.
===========================================================================
Table 2-8. Diskette Drive Test
===========================================================================
Error Code Description Recommended Action
===========================================================================
600 - xx Diskette ID drive The following steps apply to error
types test failed codes 600 - xx through 698 - xx:
601 - xx Diskette format 1. Replace the diskette media and
failed retest.
2. Check and/or replace the diskette
602 - xx Diskette read test power and signal cables and retest.
failed 3. Replace the diskette drive and
retest.
603 - xx Diskette write, 4. Replace the system board and
read, compare test retest.
failed
604 - xx Diskette random
read test failed
605 - xx Diskette ID media
failed
606 - xx Diskette speed test
failed
609 - xx Diskette reset
controller test
failed
610 - xx Diskette change
line test failed
697 - xx Diskette type error
698 - xx Diskette drive speed
not within limits
---------------------------------------------------------------------------
699 - xx Diskette drive/media 1. Replace media.
ID error 2. Run the Configuration and
Diagnostics Utilities.
===========================================================================
Table 2-9. Serial Test Error Codes
===========================================================================
Error Code Description Recommended Action
===========================================================================
1101 - xx Serial port test 1. Check port configuration
failed 2. Replace the system board and retest.
===========================================================================
To Next Page
Loading...
