Hardware Guide 6–1
6
External Device Connections
Connecting a Standard Device
The jacks and connectors described in this guide support standard
external devices.
■
For information about which jack or connector to use, refer to
the documentation included with the device.
■
For information about installing or loading any software
required by the device, refer to the device documentation, the
operating system Help files, or the device manufacturer’s
Web site.
To connect a standard external device to the notebook:
1. If you are connecting a powered device, be sure the device is
turned off.
2. Connect the device to a jack or connector on the notebook.
3. If you are connecting a powered device, plug the device
power cord into a grounded electrical outlet.
4. Turn on the device.
✎
If a properly connected external monitor or other display device
does not display an image, try pressing the
Fn+F4
hotkeys to
switch the image to the new device.
To disconnect a standard external device from the notebook, turn
off the device (if it is powered), then disconnect the device from
the notebook.
265656-001.book!!Page!1!!Monday,!June!17,!2002!!10:00!AM
To Next Page
Loading...
