8-17
HOW TO USE YOUR CARAVAN’S EQUIPMENT
Step Two: Insert plug into wall socket and close lid to lock into place.
Figure 2a + b: Insert Plug into Whale Watermaster® Easi – Slide™ Socket
Step Three: Adjust dust cover over opening in container.
Please note: The dust cover must not be secured to container, as air must be able to enter the
container, to replace the water as it is pumped
out.
Step Four: Switch on 12 Volt supply at control panel (isolator switch). The pump should start to
run.
Step Five: Open one cold tap (Whale® recommend the shower).
Step Six: After trapped air has been expelled, water will flow from the tap.
Step Seven: When air has been expelled, turn off the tap. The pump will turn off after
approximately 10 seconds.
Fig 2a + b: Insert Plug into Watermaster® Easi-SlideTM Socket
To Next Page
Loading...
