3-6
4. Fan Control Enable
When this channel is enabled, and PTT #1 turns ON, the Fan Control output J3-8 will turn ON. After PTT
#1 turns OFF this fan control output will remain ON for an additional 60 seconds. Use this output to
control a fan relay to cool the repeater’s transmitter. When this channel is enabled, User function switch
#6 on, off, and momentary operation is not available.
5. Voice Identification Enable
When this channel is enabled, the CAT-200B will identify in voice, using message #1. When this channel
is disabled, the CAT-200B will identify in CW only.
6. Voice Identification Link Inhibit Enable
When this channel is enabled, the CAT-200B will not accept an input from the link port while the voice
identification is being sent on the repeater port.
7. Forced DTMF Entry D Key
When this channel is enabled it is possible to force a DTMF command even while port #1 is active. To
force a DTMF command, end the command with a [D].
8. CTCSS Encoder Switch Enable
When this channel is enabled, user output switch #5 is converted into a CTCSS Encoder Switch output.
When Port #1 goes active, user output #5 J2 pin 7 will turn ON. After Port #1 goes inactive, user output
#5 will turn OFF. Use this output to control an external CTCSS encoder. When this channel is enabled,
User function switch #5 on, off, and momentary operation is not available.
To Next Page
Loading...
Need help?
General