Need help?Do you have a question about the Computer Automation CAT-200B and is the answer not in the manual?
Vocabulary base of 335 words for ID and announcements.
Connects to Peet Brothers Weather Station for announcements.
Technical details of the CAT-200B, including microprocessor and memory.
Eight-position dipswitch configures various CAT-200B functions.
Change channel status (ON/OFF) via DTMF commands.
Master switch for repeater operation.
Disables repeater audio during DTMF tones.
Test radio keypad and read back decoded numbers.
Requests a weather report using prefix and condition number.
Resets settings and loads defaults via dipswitch #7.
Stores 8 user-programmable timers.
Connects receiver audio and COR to CAT-200B.
Adjusts audio mixing/switching circuits for input/output.
Connects weather station to CI-200 and configures CAT-200B.
Lists all available voice words and their codes.
Schematic diagram of the CAT-200B controller board.
Schematic of the CAT-200B controller board.
List of parts for the CAT-200B controller.
List of parts for the CI-200 Interface Board.
Setup for CAT-200B in transceiver mode with weather station.
Control channels for Transceiver mode Zone 1.
Connects computer to CI-200 for programming CAT-200B.
Eliminates DTMF chirps and squelch crash noise.
Connects up to three transceivers to CAT-200B link port.
Configures COR polarity and port settings for RLS-1000B.
General| Manufacturer | Computer Automation |
|---|---|
| Model | CAT-200B |
| Category | Controller |
| Input Voltage | 115/230 VAC |
| Output Voltage | 5 VDC |
| Operating Temperature | 0 to 50°C |
| Storage Temperature | -20 to 70°C |
| Weight | 25 lbs |
| Humidity | 5 to 95% non-condensing |
To Next Page