7 / 16
Motion detection setup. Set DVR equipment to activate an alarm, linkage record and make the PTZ
return to the preset position when there is a moving object detected in a designated area between
Monday and Friday.
Step1. Choose
【
Main Menu
】
>
【
Alarm
】
>
【
Motion Detect
】
,then enter the setup interface.
Step2. Choose one channel and adjust sensitivity level, then set the time period of alarm surveillance. Set
the monitor area (click the “set” button to choose the areas you want, or the “default” button to choose
all areas, then right click to choose "up window".
Step3. When at the alarm stage, the DVR can take linkage measures. Alarm output, recording, tour, PTZ
activation, snapshot, show message, sending email (need to set email parameters at net service) and
buzzer (local buzzer).
Step4. Set other channels alarm parameters by following step 2 and step 3.
Note: Video blind, video loss and alarm input’s setup method are similar to motion detection.
10. PTZ Control
Perform simple PTZ control via below steps:
Step 1:
【
Main Menu
】
>
【
System
】
>
【
PTZ, to set parameter of channel, protocol, etc.
Step 2: under preview status, enter single window of PTZ control
；
Step 3: perform a single click of the right button, then choose PTZ control. Choose normal function or
high-speed . Click left button to operate PTZ directly, then move the mouse to control the direction of
PTZ. Use the mouse roller to zoom in or zoom out of the image.
Part two: Remote Control
1. Remote Control
After successfully connecting to a network, users can remote monitor in two ways: multi-device client
software or common browser. Multi-device client software CMS is a professional software used for remote
monitoring of multiple devices, with the added benefits of safety, convenience, stability and centralized
management. This also negates the need to install activeX , therefore we recommend use of CMS. Remote
monitoring by browser is performed via the kernel browser in an individual’s PC, such as IE, Chrome, etc.
2.Multi-device manage platform software – CMS
CMS centralizes management of the DVR and networked devices, allowing control through one PC.
Step 1: CMS software is included with the DVR. Open the enclosed CD, then follow the tips to install it.
Step 2: After installing this software on the local PC, log onto the interface as in picture 7, enter the “add
To Next Page
Loading...
