10 / 16
3.1Basic remote control operation
To do remote control at the interface of pic 9
3.2 Screen Split
To choose the mode of preview
3.3 Playback
Enter playback area, can support multi-channel playback at the same time.
3.4 Log
Show log information
3.5 Local config
To set device alarm, enable linkage function on the remote network client side.
3.6 Channel control
Open the video, choose the video on the left video window and then choose channel on the right. Double
click it to open the first video, then choose another channel and double click to open the second video.
Perform the same action to open all subsequent channels. If the channel did not change, system will close
previous video and open the new one you choose.
Note: user can choose the most appropriate image mode when opening remote video control.
Close video: at the video window, choose the video that you want to turn off, right click it and choose to
shut the window. All the windows can be closed at the same time by selecting to close all.
3.7 Remote config device
At preview window, single click right button, choose ‘device config’. This will configure the parameters of a
device, which will be synchronized to local side including: record, alarm, system, advanced, Info, etc.
4.Access device in public network (Cloud operation)
Guide
Visit http://xmeye.net to see below login page. This is divided into two modes; login by user
and by device. The user can choose between these options to maximise convenience.
*Note: to log in “by user”, the user needs to register the first time.
To Next Page
Loading...
