Mechanical Key Cutting Machine CONDOR XC-002
4.3.10 STORAGE BOX
To place tracer, cutter, key blank, brunch and other materials and tools.
4.3.11 POWER CONTROL MODULE
The power connector, fuse and power switch are all located at the lower
back of the machine.
1) Insert the power cord into left port, then link to the grounded power
outlet.
2) When switch the power to “ON”, machine enters into “Standby”
mode.
3) To replace the fuse, please remove the box first, then change a new one
and put the box back.
14
To Next Page
Loading...