following commands.
Z - Tares the balance. (Make weight and count reading zero)
T - Tares the balance. (Make weight and count reading zero)
W1 – Request for weighing and counting data
However scale can be operated in a continous data transfer mode when it will send data
continuously as it measures. This can be set using scale keyboard.
SETUP FUNCTIONS
SETUP functions control the basic operation of the SCALE. These parameters can be set by the user
to suit the requirements. The following are the parameters.
MENU NAME FUNCTION OPTIONS DESCRIPTION
Factory setting To select factory set parameters.
Baud rate setting To select 2400 baud rate
To select 4800 baud rate
Print modes set. Send stable weight through serial port
when key is pressed.
Send weight through serial port
Every time scale reading becomes
stable.
Send weight continuously.
Auto zero setting. Autozero disabled.
(Ability of the scale to remain Autozero to half accuracy of scale.
at zero, when there is no weight Autozero to full accuracy of scale.
on the pan. ) Autozero to twice the accuracy of scale.
To Next Page
Loading...
General