Edition 05/2021 – CC200 D – Notice technique – page 9
SACOME, Document CONFIDENTIEL, Ne peut être reproduit ni communiqué sans notre accord préalable.
7. PROGRAMMING PROCEDURES
7.1. COFFEE DOSAGE PROGRAMMING
Programming is done on the group 1 (left group), the 5 keys are defined as follows:
+ - ENTER MENU
P1 Gr1 P2 Gr1 P3 Gr1 P5 Gr1
1shot 2shots 1regular continuous
espresso espresso coffee flow
2 ways of programming are possible to set the coffee dose.
➢ Choose 1st group (on the left when the user is in front of the machine)
o To program all groups at the same time with the same value.
o The programmed key will have its equivalent key programmed identically on the others groups
➢ Choose the others groups separately, if the groups need to have different value.
Methodology:
Put the ground coffee (1 dose or 2 doses according to the programmed key), in the suitable filter holder.
Press the key n°5 "P5 Gr1" from the selected group during 10 seconds, until it’s blinking.
Release the key n°5 "P5 Gr1"
Display shows “Press dose selection within 30s”
The operation can start in a delay of 10 seconds. Otherwise it go back from the programming mode.
Press the key to be programmed to start the flow, and press again when water quantity is correct. The
value is directly registered.
Then, continue programming the next key within 10 seconds, and so on for the other keys.
You can use any coffee button after the message “Press dose selection within 30s” disappears
Note : On the factory, each machine undergoes a test protocol on which a program has already been
completed, according to the following settings:
1 espresso = 2,5 cl / 2 espressos = 5 cl / 1 coffee = 4,5 cl / 2 coffee = 9 cl
To Next Page
Loading...
