Edition 05/2021 – CC200 D – Notice technique – page 19
SACOME, Document CONFIDENTIEL, Ne peut être reproduit ni communiqué sans notre accord préalable.
10. SUMMARY OF THE PROCEDURE RESETTING THE COUNTERS
10.1. HOW TO RESET THE COFFEE COUNTER
Put the machine in the "ECO" mode with the key "P5Gr1" and "P3Gr1"
Enter in the programming mode, pressing during 10 seconds the "continuous" key (P5Gr1).
Repeat to press this "P5Gr1" key several time in order to reach "Coffee counters" menu.
Press the key "P3Gr1" to enter in this menu: the display shows «Cumulative total».
Press the key "P4 Gr1" for 3 seconds,
The display shows then « Total Reset ».
Only the counters of each key is reseted. The total counters of products is not reseted.
10.2. RESETTING DATA
If necessary, it is possible to re-configure the machine with data by default.
The procedure is as follows:
• Turn off the power supply of the machine.
• Keep pressing simultaneously the keys “P1 Gr1” + “P3 Gr1”+”P5 Gr1”
• Turn the machine on.
• the display indicate
To return to normal operation, turn off and on the machine.
10.3. PROCEDURE TO RESET THE WATER COUNTER :
When the programmed amount of water has been consumed by the machine, the message "Change
Filter" and the service phone number to contact, appears on the display
This message prompts the user to change the cartridge system of water treatment but does not forbid
the distribution of products.
Once the cartridge has been changed, you have to clear the message:
- Switch off the machine (the button ON / OFF).
- Keep pressing the keys “P3 Gr1” and “P4 Gr1” (on left group).
- Turn on the machine (the button ON / OFF), the display shows:
The count resumed at zero.
To Next Page
Loading...
