Edition 05/2021 – CC200 D – Notice technique – page 31
SACOME, Document CONFIDENTIEL, Ne peut être reproduit ni communiqué sans notre accord préalable.
16. OPTION AVAILABLE
16.1. SOLO KIT
In case of insufficient pressure on the water system, or if the water supply is non-existent, you must use
separate water tanks.
The machine must operates in SOLO mode:
➢ The filling up must be parametered "WITH PUMP" (P1 + P4)
➢ The machine draws its water from the bucket provided.
We offer for that a solo kit No. 411618 (order separately)
This kit consists of the following elements:
➢ 1 corrugated input to connect at the inlet of the machine (409195)
➢ 1 hose to connect to the corrugated input (464419)
➢ 1 "strainer + non return valve” to connect to the other side of the hose (409630+406986)
The role of the strainer is to ensure that the pump remains primed again.
The role of the strainer is to ensure that the pump remains primed again.
Feeding 3/8"
It is compulsory to fill up manually the silicone pipe with water before first starting
the machine for the pump to prime properly, without risk of deterioration.
To Next Page
Loading...
