EasyManua.ls Logo

Conti CC202 - CAUTIONS DURING USE; Safety and Environmental Precautions

Conti CC202
34 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Edition 05/2021 CC200 D Notice technique page 3
SACOME, Document CONFIDENTIEL, Ne peut être reproduit ni communiqué sans notre accord préalable.
3. CAUTION DURING THE USE
3.1. AMBIENT CONDITIONS
The ambient temperature around the machine had to be between 5°C et 32°C.
The ambient humidity must not exceed 70 %
The machine must be placed such as the cup warmer is located more than 1.5 meters from the ground.
3.2. DURING INSTALLATION
The installation (electrical connections, water supply and drainage) must be carried out by a qualified
technician approved by CONTI.
The machine must be connected to a device conforming to the standards of the country where the
machine is installed. Potential costs of equipment compliance are the only responsibility of the
customer.
For any technical intervention, the machines must always have the power disconnected from the mains.
An effective earth connected to the terminal provided for this purpose on the device is mandatory
A screw located under the bottom base machine, allow if necessary, to connect several machine on an
equipotential way.
Devices for disconnection from the main supply, having a contact separation of at least 3mm in all poles,
must be provided in the fixed wiring in accordance with the installation rules.
3.3. DURING THE USE
When the machine is not operating, the water cut-off valve has to be closed and the electrical power
supply cut.
When the machine is not supervised it must be disconnected from the power and water supply.
Never disconnect the earthing when the machine is connected to the power supply.
Machines must always be disconnected from the main power, in case of technical interventions.
We guarantee our machines subject to a correctly sized water treatment is installed backward and
adjusted according to the carbonate hardness of the water network.
3.4. RULES RELATING TO THE ENVIRONMENT
This device has been designed according to the European Directive No. 2002/95/EC. This refers to the
restriction of certain hazardous substances in electrical and electronic equipment (ROHS)
This device has been designed in compliance with the European Directive No. 2002/96/EC concerning
waste electrical equipment (WEEE).
This picture informs you that this device should not be discarded with household waste.
At end of life, this product must be returned to a collection point or returned to an authorized dealer. By
doing so, you will help to protect the environment and human health.

Related product manuals