Edition 05/2014 - X-ONE - page 27
SACOME, CONFIDENTIAL Document,
it is forbidden to duplicate or communicate this document without previous authorization.
12 TROUBLESHOOTING FACILITATORS
12.1 STOPPING TAPS :
Somes stopping taps, located below the drip tray, allows the technician to isolate coffee circuits of each
group.
It can be usefull to remove a defective part (flowmeter as exemple), and keep the machine operating on the
other groups.
12.2 DATA RESET:
It is possible to restart the machine, machine will then have the standard settings.
Procedure:
_ Cut the mains.
_ Press continuously buttons n° 1, n° 3 and n° 5 on group 1 while
_ Put back the mains.
_ If display shows «preset valori completato», RESET is done.
To go back to normal use, cut and put back the mains.
12.3 COLD CONDITIONS FUNCTIONNING:
UNDER CONSTRUCTION
To Next Page
Loading...
