Table of Contents
Topic Page
Table of Contents 2
Part 1: Introduction 3
Overview 3
Installing the RollerMouse Pro software 4
Plugging the RollerMouse Pro into a USB port
Plugging the RollerMouse Pro into a PS2 port
Opening the Contour Mouse Control Panel 5
Part 2: Contour Mouse Control Panel Components 7
Motion 7
Buttons & Wheel 8
Application Specific 10
About 12
Part 3: Removing the RollerMouse Pro Software 12
Part 4: Software License Agreement 12
Part 5: Contour Customer Care 15
Registering Your RollerMouse Pro 15
Trouble Shooting 15
Technical Support 16
Notice: Your RollerMousePro® Multi—Language User’s Guide contains instructions
for three levels of settings for the DIP switch found under a removable panel under the
RollerMousePRO. Installation of the driver software should mean that leaving the DIP
switch in the “Standard Mode” position will suffice to perform Driver functions
WITHOUT HAVING to reset the DIP switch.
It is the expressed intent of CDI not, at this time nor for any time in
the foreseeable future, to provide the Software on a CD, It is
assumed that users, who wish to install and use the Software, will
do so from some download. In cases where download of the
Software in impossible or impractical, CDI will – upon request –
issue a copy of the Software on a CD.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
