Control 4 Multi Channel Amplifier16 - Requirements; Whats in the Box; About the Multi Channel Amplifier; Front View

6
Requirements
 Ensure that your home network wiring is in place
before starting your system setup. The Multi Channel
Amplifier can be controlled through Ethernet or
through ZigBee mesh networking (IEEE 802.15.4).
 Device must not be installed in a cabinet that is
smaller than 20” wide x 20” deep x 12” high.
What’s in the Box
The following hardware and software is required and
included in your Control4 Multi Channel Amplifier box.
 Control4 Multi Channel Amplifier - 16
 IEC power cord
 This manual
About the Multi Channel Amplifier
Front View
1. Front Display—LCD for displaying or setting
Multi Channel Amplifier settings and
navigating system menus. The front display
is used to view or modify audio source
1
2
3