17
Manage Amplifier Output Zones
View or Change Output Settings
To view or change source settings:
1. On the In to Out Assignments screen, press the
Setup button.
The output settings of the default output screen (the
last output screen accessed) are displayed.
In the following example it is Output Zone 1. You can
choose to view the settings for a different output
screen by changing the output number (see Step 2).
You can adjust the output settings by scrolling with
the Select Dial, pressing the dial to edit, using the up
or down button or the dial to change the setting, and
pressing OK or the Select Dial to save changes.
Input (number): If an input source is assigned,
the Input source number is displayed (1 - 16).
Gain (setting): Supported range: Mute INF
0 - 99 (-100 to 0 dB)
NOTE: The gain setting cannot be larger than the
volume limit.
Limit: Set a volume limit. Options are 0 - 99 or
off.
Balance: Determine output balance. Options
are Center, Left, Right, L-1 - L-19, or R-1 - R-19.
To Next Page
Loading...
