46
CONTROLLER SETUP
When navigating through the Main Menu you will arrive at the Controller Setup selection. To
configure the module to new settings, you can enter into this area by pressing the Enter Button
PASSWORD ENTRY
The next screen will ask for a password. If no password, or an incorrect password is used, navigation
into the menu is still possible and permitted, however, the ability to make changes will be restricted.
To enter the password, press the Enter button and brackets will appear. Use the Up and Down arrow
buttons to set each digit individually, pressing the Enter button to index to the next digit from left to
right.
Once the last digit is entered, the Setup Menu will be displayed and the selected sub topic will be the
Quick Setup menu. Programming can continue.
Multi-Level Passwords can be configured through CI Station for OEMS that wish to do so.
To Next Page
Loading...
Need help?
General
