CONTROLS, INCORPORATED
C O N T R O L S Y S T E M S & S O L U T I O N S
- 22 -
Regen Fail / Abort
The regen process will be aborted if either the Neutral Switch or the Parking Brake circuits open
during the process. When this occurs, a message will appear requiring the operator’s
acknowledgement.
The condition causing the abort will need to be rectified and the regen process reinstated from the
beginning.
There may be situations that cause a regen to fail or be aborted by the engine ECU. When this
happens, the controller will post a message such as Regen Failed or Regen Aborted. Each of these
screens will require the operator’s acknowledgement. When these circumstances occur, the
operator should contact a dealer for instructions.
To Previous Page
Loading...
