Convotherm mini OES 6.06 - Network Address, Language

Set-up
- 20 - EN
Network address
The network address is required for the use
of PC Control, PC-HACCP and the
CONVOTHERM Service System.
You can set the network address from the
‘Setup’ menu
.
1. Use the selector dial to select ‘Network
address’
and confirm by pressing
the
button. → In the display will
appear the network address that is
currently set. Using the selector dial,
select the desired network address
(1 - 99) and confirm by pressing the
button.
N.B.:
The network address 1 is always set in the
factory. Ensure that you select a different
network address for each of your
appliances.
Language
You can select your language from the
‘Setup’ menu
.
1. Use the selector dial to select
‘Language’
and confirm by pressing
the
button. → A list of the possible
languages will appear in the display.