Firmware Update
CoolMaster PRM
29
www.coolautomation.com
© 2015 Cool Automation LTD
Rev 4.08
CoolMaster will react with running address counter on its LCD screen. The whole process may take
about a few minutes, and it ends with "EOF" and shortly afterwards "READY" messages on the LCD
screen.
5.3 Reboot
After firmware downloading has being finished you need to power reset CoolMaster. If it was entered
bootloader mode with BOOT jumper, please make sure to close BOOT jumper back before power
reset.
To Previous Page
Loading...
Need help?
General