18
AUXILIARY X TAMP
12:00 Sun 01 JAN
The control unit has auxiliary tamper zones
for monitoring auxiliary devices. The lid of a
device has been removed. You may not
be able to set your system until the fault is
cleared.
BELL TAMPER
12:00 Sun 01 JAN
The lid of the external sounder has been
removed. You may not be able to set your
system until the fault is cleared.
TEST CCTS FAILED
12:00 Sun 01 JAN
One or more zones failed during a test
routine initiated by your alarm company.
You can still set and unset your system but
you should contact your alarm company.
TAMPER 0001
Office Window
This message is displayed when a zone's
tamper circuit has been activated.
CALL ENGINEER TO
RESET SYSTEM
An engineer code or remote reset code
needs to be entered to reset the system.
Reset Required
See CALL ENGINEER TO RESET SYSTEM.
RING A.R.C. FOR
REM. RESET CODE
You need to contact an Alarms Receiving
Centre for a remote reset code (see page
15).
To Next Page
Loading...
