20
entering your user code and selecting the
"
Defer Setting" option.
Engineer on Site
12:00 Sun 01 JAN
An engineer from your alarm company is
on site and logged into the alarm system. If
required, you can operate the system as
normal. The message is automatically
cleared when the engineer logs off.
SYSTEM IS BUSY
PLEASE WAIT
Another user is accessing the alarm system.
You cannot use your keypad until this
message has cleared.
Sorry,cannot set
Aux X tamp open
Cannot set because of a tamper fault on
auxiliary zone 1 or 2. Clear the fault.
Sorry,cannot set
Bell box tamper
Cannot set because of a tamper fault on
the external sounder. Clear the fault.
Sorry,cannot set
Equipment faulty
Cannot set because of a fault from one or
more system components (shown). Clear
the fault.
Sorry,cannot set
Zone in fault
Cannot set because of a fault from one or
more zones (shown). Press ] to show the
zone in fault. Clear the fault.
Sorry,cannot set
Panel lid tamper
Cannot set because of a tamper fault on
the control unit. Clear the fault.
Sorry,cannot set
Mains Power off
Cannot set because there is no mains
power at the control unit. Clear the fault.
Sorry,cannot set
Phone line fault
Cannot set because of a line fault from the
remote signalling device. Clear the fault.
To Next Page
Loading...
