Cooper Security M2000 - Obtaining a Remote Reset Code

15
Press ENT
To Reset
4. You will see the message shown
opposite once you have reviewed each
message. Press [ to reset the system.
The ALERTS message should not appear
again, unless:
• The condition still remains (e.g. a mains
failure).
• You need to call an engineer.
• A remote reset code is required (see
below).
Press 0 to Set
5. EITHER press “0” to carry on and set
the system.
OR press ] to return to the standby
screen without setting.
Obtaining a Remote Reset Code
RING A.R.C. FOR
REM. RESET CODE
You will see this display if you need to
obtain a remote reset code from an Alarm
Receiving Centre (ARC)
1
.
To obtain and enter the remote reset code:
Press ENT
To Reset
1. Press [ at this message.
- REMOTE RESET –
Quote > 5820
2. Make a note of the displayed code. The
code may be 4 or 6 digits
2
.
(The top line of the display may have
been customised by your alarm
company
3
).
3. Contact your ARC and quote the code.
1
Engineer option 25
2
Engineer option 47
3
Engineer option 74