5
Operating your Alarm System
Setting Your Alarm System
To set the system or a ward carry out the
following steps:
1. Identify yourself at the keypad
2. Choose the ward(s) you want to set.
3. Leave the premises and complete setting.
)
First, check that everyone has left all
relevant areas, and close all doors and
windows securely. You cannot set the
system while a zone is active (see page
19).
BANNER TEXT
17:30 Sun 01 JAN
1. Identify Yourself:
At the keypad, key in your user code or
present your proximity tag.
)
If you change your mind, you can press
] to exit without setting the system.
Set Selection
Ward > **......
2. Choose Wards:
The bottom line of the display uses a "*"
character to show the wards you can
set
1
. In this example, you can set wards
1 and 2, but not wards 3-8
1
Your user code settings (User option 8-1) determine the wards you can set
To Next Page
Loading...