22
BELL TAMPER
12:00 Sun 01 JAN
The lid of the external sounder has been
removed. You may not be able to set your
system until the fault is cleared. Contact
your alarm company.
TEST CCTS FAILED
12:00 Sun 01 JAN
One or more zones failed during a test
routine started by your alarm company. You
can still set and unset your system but you
should contact your alarm company.
TAMPER 0001
Office Window
The display shows this message when a
zone's tamper circuit has been activated.
Contact your alarm company.
CALL ENGINEER TO
RESET SYSTEM
An engineer code or remote reset code
needs to be entered to reset the system.
Reset Required
See CALL ENGINEER TO RESET
SYSTEM.
RING A.R.C. FOR
REM. RESET CODE
You need to contact an Alarms Receiving
Centre for a remote reset code (see page
15).
To Next Page
Loading...