Cord DJ-U Pro - Page 10

Connecons Cont’d
*Important Notes on Phono vs. Line Inputs & Outputs:
It is not suitable to use the PHONO output of this turntable with a LINE Input on your Amplier or
Receiver. If you do connect this unit to a LINE INPUT when the switch is set to the PHONO posion, the
resulng playback will be very low and almost inaudible.
It is even more important that you do not use the LINE output of this turntable with a PHONO Input on
ANY Amplier, Receiver, etc. If you do connect this unit to a Phono input when the switch is set to the
LINE posion, the resulng playback will be extremely loud and distorted and may easily cause serious
damage to your equipment, including your loudspeakers.
3. USB Cable Connecon:
Connect the USB output on the Turntable to any available USB input on your PC or Mac Computer. This
will enable you to record from your vinyl to an MP3 digital audio le using the free Audacity soware.
4. Power Cable Connecon:
Plug the mains power cable into your homes 240V mains power outlet and switch ON.
Adjusng the Tonearm & Stylus
TONEARM BALANCE ADJUSTMENT:
1. Set the ANTI-SKATE dial to ‘0’ posion.
2. Remove the Stylus cover.
3. Release the arm rest clamp and set the cueing lever to the up posion to li the tone arm up and o
the arm rest.
4. Move the tonearm over to the space between the arm rest and the plaer, taking care not to dam-
age the stylus.
5. Set the cueing lever to the down posion.
6. Support the headshell’s nger-li with one nger and aain level balance by turning the counter-
weight either clockwise or counter-clockwise. ‘Level balance’ means when the tonearm is parallel
to the plaer, and the tonearm therefore sits sll half way between the full up posion and the full
down posion of the tonearm movement range. The tonearm should not lt either toward the coun-
terweight side or the headshell side. Once the tonearm is hovering perfectly horizontal, the stylus
tracking weight is now set at zero.
7. Return the tonearm to the arm rest and fasten the arm rest clamp.
8. As the tracking force is zero when the tone arm is balanced level, turn only the tracking-force scale
ring in front of the counter-weight, and set the ‘0’ posion on the scale to the index line on the top
of the counterweight sha. Be sure to hold the counterweight with the other hand so that it does
not turn together with the scale ring.
9. Now turning the counterweight and scale ring together, set the correct tracking force opposite the
index line on the counterweight sha. The tracking-force scale ring has 0.1 gram steps and one full
turn of the counterweight will yield a tracking force of 4.0 grams.
9