xv
166240001
OWNER -OPERATOR
The installation is not complete until you are sure the owner-operator understands the cuber operation and his
or her responsibility of preventative maintenance.
Does the owner-operator know:
1. Location of electrical disconnect switch and water shut-off valves?
2. How to start and/or shut down the product, clean and sanitize it?
3. Bin full operation and reset operation of high pressure cutout (water-cooled and remote products only)?
4. How to clean the condenser and fan blade?
5. Whom to call for product information and/or service?
CLEANING PROCEDURES
Approved ice machine cleaners by brand names:
S Lime–A–Way
S Calgon Nickel Safe (green color only)
NOTE: All ice machine cleaners labeled safe for nickel ARE NOT the brand CALGON NICKEL SAFE.
CAUTION: Ice machine cleaners are acidic-based chemicals. Before beginning any
cleaning of the cuber, the ice in the storage bin or dispenser must be removed.
WARNING: When using any chemical, rubber gloves and eye protection should be worn.
PREP – CLEANING
Use full-strength ice machine cleaner on a coarse-surface cloth material (such as terry cloth) and wipe down the
inside wall of the evaporator area, the water pan, the water curtain and evaporator plastic extrusions. If the wa-
ter distributor tube has heavy scale build–up, remove and soak it in full-strength ice machine cleaner (or ex-
change the tube and clean the scaled tube at a later date).
Cleaning the Water System & Evaporator
1. Set the switch to Clean and allow any ice on the evaporator to re-
lease and melt away.
2. Remove all ice from the storage bin.
3. Remove the water curtains, pour 1/2 oz. of ice machine cleaner
down the rear key-slot openings. The cleaner will drain into the wa-
ter pan.
4. Return the water curtains to their proper operating position.
5. Add 3 oz. for a single evaporator, or 5 oz. for a dual evaporator of
“Calgon Nickel-Safe” or “Lime-A-Away” ice machine cleaner direct-
ly into the water pan the float will balance with inlet water. Set
switch to CLEAN, circulate for a maximum of 15 minutes.
POWER
SWITCH
To Next Page
Loading...
