1-5
• Check bilge pump, horn, lights, blower and other
equipment to verify they are operating properly.
• Verify that the emergency cutoff switch lanyard is in proper
operating condition and is properly affixed to the driver.
• Check the operation of the steering system. Verify that the
steering is operational before launching the boat. If the boat
is already in the water, verify proper steering wheel operation
at low speed. Turn the steering wheel full stop in both
directions and verify proper rudder movement. Ensure that
there is no binding or stiffness in the steering wheel
rotation. Binding and stiffness is an indication that the
steering cable needs replacement. Failure of the steering
cable will result in loss of control of the boat.
• Ensure that the load of persons, ballast, and equipment is
within the limits stated on the USCG Maximum Capacities
Plate and is properly distributed based on instructions in this
manual.
• Check that all safety equipment and life jackets, personal
flotation devices (PFDs), and throwable cushions are in good
condition and suitable for your boat and passenger load.
• Inform all passengers where safety equipment is located and
how to use it.
• Have at least one other passenger who is capable of
operating the boat safely in case of an emergency.
- It is very important to open the engine cover and check
the engine compartment and bilge for liquid gasoline and
gasoline vapors prior to each use of your boat and after
refueling. Failure to do so may result in fire or explosion
as well as serious injury or death to you and/or others.
Boating Safety
Gasoline vapors can explode. Before
starting engine operate blower for 4 minutes and check
To Next Page
Loading...
