7-18
Rudder Remote Lube Fitting
The remote lube fitting allows for easy access to lubricating the
rudder. The remote lube fitting is located at the stern of the engine
compartment. Use a quality marine grease and gun. Connect the
grease gun to the fitting and apply a light pressure to the gun until
you feel a slight resistance.
Transmission
Allow the transmission to cool and check with the boat level.
1. Remove the drain/fill plug from the transmission.
2. Verify the fluid level; the fluid level should be at the bottom of
the threaded hole. If low, add the specified fluid through the
threaded hole to the proper level.
The transmission fluid is a very high viscosity. To make adding
fluid easier, remove both fill plugs.
3. Replace the drain/fill plug and tighten securely.
Section 7
Burn hazard from hot transmission fluid
can cause serious injury. Do not remove the
transmission drain/fill plug while the engine is running
or while the transmission is hot.
To Next Page
Loading...
