45
4-8-2 Applying Static Network Settings to D11
1. Select D11 in the tree at the left windows.
2. Select the ”NETWORK” in the device menu.
3. De-select the “Enable DHCP” item.
4. In the ”Primary DNS” field, enter the IP address of the DNS server (Domain Name
System Server). Usually, this is the address of the router.
5. Enter the Gateway IP address of your network into the ”Gateway” field. Usually, this is
the address of the router.
6. In the ”IP Address” field, enter the static IP address, under which D11 is to be
accessed in the local network.
7. In the ”Subnet mask” field, enter the subnet mask of your network. Normally you can
find this information in the router manual.
8. Select [Save Config]. D11 saves the network settings. The save procedure can take
up to 10 seconds. Do not separate D11 from the electricity supply during the save
procedure. If you disconnect D11 from the energy supply during the save procedure,
your data can get lost.
9. When the save procedure is completed, remove the plug-in power supply of D11 from
the plug socket.
10. Remove the network cable.
You may now connect D11 to the local network.
4-8-3 Activating/Deactivating DHCP
D11 can obtain its network settings via a DHCP server (Dynamic Host Configuration
Protocol). D11 automatically obtains the IP address, the subnet mask, gateway and the
DNS address from the DHCP server in order to establish D11 in your network.
Activating DHCP
1. Select D11 in the tree and select “NETWORK” in the device menu.
To Next Page
Loading...