1
1. Safety Instructions
WARNING!
Before installing and using the inverter, please read the
following safety information carefully.
1-1. General Safety Precautions
1-1-1. Do not expose the inverter to water, mist, snow, or dust. To
reduce the risk of hazard, do not cover or obstruct the
ventilation shaft.
To avoid overheating, do not install the inverter in a
zero-clearance compartment.
1-1-2. To avoid the risk of fire and electronic shock, make sure that
existing wiring is in good electrical condition and not undersized.
Do not operate the inverter with damaged or substandard
wiring.
1-1-3. There are some components in the inverter that can cause arcs
and sparks.
To prevent from fire or explosion, do not put batteries,
flammable materials, or anything that should be
ignition–protected around the inverter.
1-2. Precautions When Working with Batteries
1-2-1. If battery acid contacts your skin or clothing, you need to wash it
out immediately with soap and water. If acid enters into your
eyes, immediately flush your eyes with running cold water for at
least 20 minutes and get medical attention immediately.
1-2-2. Never smoke or make a spark or flame in the vicinity of batteries
or engines.
1-2-3. Do not drop metal tools on the battery. The resulting spark or
short-circuit on the battery or other electrical parts may cause an
explosion.
1-2-4. Remove personal metal items such as rings, bracelets,
necklaces, and watches when working with a lead-acid battery. A
lead-acid battery may produce a short-circuit current whose
temperature is high enough to weld these metal items and cause
a severe burn.
To Next Page
Loading...
