If the water pressure exceeds the maximum
allowable water inlet pressure (1～5bar),
please purchase a water pressure
regulating valve；
A manual water supply valve must be
installed before all water supply pipes
of the ice machine。
6.2 Drainage
When installing the drain pipe, to prevent
water from flowing into the ice machine bin,
please follow the following guidelines：
The main drainage pipe should be able to
drain the water in all drainage branches；
The drain pipe of the storage
refrigerator should be covered with
insulation material to prevent
condensation；
The drain pipe of the water-cooled
condenser and the drain pipe of the
storage refrigerator should be placed
separately;
Every additional meter of drain pipe
must have a drop of 2.5 cm and no bends.
7. Power supply
The power supply voltage, frequency and
power supply capacity must be consistent
with those marked on the machine nameplate；
Allowable voltage fluctuation range is
±10% of rated voltage；
The ice machine must be equipped with a
circuit breaker separately.
8. Cleaning After
Installation
After the ice maker is installed, clean the
shell, inner container and ice shovel of the ice
maker with a clean damp cloth/sponge;
9. Check After Installation
After the ice maker is installed, check the
following contents before running
Is the ice machine even?
Have all the inner packaging been
removed?？
Are all the water and electricity
connected?？
Does the supply voltage match the rated
voltage on the nameplate?？
Is the ice machine properly grounded?？
Is there a proper space around the ice
machine for air circulation？
Is the ambient temperature of the ice maker
between 10°C and 38°C?？
Is the inlet water temperature at the
installation point of the ice maker
maintained between 5°C and 32°C?？
Are the ice machine and refrigerator clean?
To Next Page
