COTLIN LB Series - Remove the Top Cover and Back Panel; Evaporator Cleaning

安全提示
No.：JT190100017 Version No.：A0
Note: The subsequent versions of this manual are subject to change without notice, thank you
9 / 21
Routine cleaning
13.1 Remove the top cover and back panel
 Remove the top cover of the ice maker. There
are two screws on the top cover and the back
of the ice maker. Use a Phillips screwdriver
to remove them
Lift the top cover slightly upwards first, and
then gently pull back to pull out the top cover
 emove the back plate of the ice machine. Use
a Phillips screwdriver to remove the two
screws on the upper part of the back plate.
Lift the back plate upwards slightly to remove
the back plate (Note: the drain pipe is placed
on the back plate, gently pull Backboard,
placement;
13.2.Evaporator cleaning
 Use a brush or sponge dipped in descaling
agent or vinegar to scrub the surface of the
evaporator;
Use nylon brush dipped in descaling agent or
vinegar to scrub the plastic parts around
▲Notice
 It is strictly forbidden to flush the ice maker
with a water jet. Do not use any
alcohol-containing liquid to clean or disinfect
the ice machine, otherwise it may cause cracks in
the plastic parts；
 Remove the top plate and back plate, but should
be disassembled by maintenance personnel with
appropriate knowledge；
 Do not put plastic parts in water or dishwasher
with a temperature of over 40℃ to avoid damage
to the parts。
★Important
If cleaning of some parts is
necessary, it is not recommended to
remove the top cover, please have the
corresponding knowledge or under the
guidance of professionals。