28 February 2017 Installation and Planning
CY460_Operational_Manual_405 Page 32 of 218
6. Check that the TriBlack 2 signal is as configured in the menu, and that selecting and
editing entries in the menu by using the rotary/push control, the configuration of the
TriBlack 2 signal changes accordingly.
7. Return to step 2, set for < Video Channel 09 = Tri Black 3 >, and repeat steps to
check the TriBlack 3 outputs.
8. Return to step 2, set for < Video Channel 10 = Tri Black 4 >, and repeat steps to
check the TriBlack 4 outputs.
9. Return to the Top Level menu using the [ Back ] button.
Serial Digital Video Signal Outputs:
Note: the format of the SDI Black 1 (& 2) output(s) follows that of the associated SDI Pattern
output; i.e. they operate as a pair of “linked” outputs.
Each SDI Video output channel can be configured to produce SD-SDI, HD-SDI or 3G-SDI.
SD-SDI Video outputs are always available. HD- and 3G-SDI outputs are only available if
the associated Option Keys have been entered; otherwise, the selection of output format is
restricted.
From the Top Level menu:
1. Select < -Video >.
2. Select < Video Channel 01 = SDI+Black 1 >.
3. Connect the SDI1 Pattern output to the Serial Digital Video Analyser using a 75Ω
BNC cable.
4. Set the Serial Digital Video Analyser to view the Serial Digital Video signal.
5. Check that the Serial Digital Video Analyser displays the appropriate Serial Digital
Video signal. If available, check the status of the Serial Digital Video signal on the
Analyser by setting it to display the relevant data.
6. Check that the Serial Digital Video signal is as configured in the menu, and that
selecting and editing entries in the menu by using the rotary/push control, the
configuration of the Serial Digital Video signal changes accordingly.
7. Move the 75Ω BNC cable to the SDI1 Black output.
8. Repeat steps 4 – 6 to confirm the configuration of the SDI1 Black output.
9. Return to step 2, set for < Video Channel 02 = SDI+Black 2 >, and repeat steps to
check both of the SDI2 outputs.
10. Return to the Top Level menu using the [ Back ] button.
SDI Embedded Audio Settings:
Note: Audio channels on the SDI outputs are arranged as 8 stereo pairs on each video output:
SDI 1 Pattern 01 … 16
SDI 1 Black 01 … 16
SDI 2 Pattern 01 … 16
SDI 2 Black 01 … 16
From the Top Level menu:
1. Select < -Audio >.
2. Select < SDI 1 Pattern Left = Audio 01 >.
3. Connect the SDI1 Pattern video output to the Serial Digital Video Analyser or to a
Digital Audio De-Embedder using a 75Ω BNC cable.
4. Set the Analyser / De-Embedder to display the status of the audio data, and to receive
a signal through the connected input.
5. Check that the Analyser / De-Embedder does not report any data errors, etc.
To Next Page